# Rack pull height

**URL:** <https://forum.barbellmedicine.com/t/rack-pull-height/161>\
**Category:** Training Q&A \[Moderated\]\
**Created:** [September 18, 2017, 6:39pm UTC](https://forum.barbellmedicine.com/t/rack-pull-height/161 "2017-09-18T18:39:25Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Oarsman05](https://avatars.discourse-cdn.com/v4/letter/o/46a35a/32.png) [@Oarsman05](https://forum.barbellmedicine.com/u/Oarsman05)\
**Post date:** [September 18, 2017, 6:39pm UTC](https://forum.barbellmedicine.com/t/rack-pull-height/161/1 "2017-09-18T18:39:25Z")

</div>

In the “Movement Explanation” section of The Bridge, it specifies that rack pulls should be done from mid-shin height or using elevated blocks. In my rack, the lowest I can set the pins puts the bar just barely below my knees. Is it better to lift from that height, or is there some other modification or alternative (RDL?) I should consider? Due to spacing issues the blocks aren’t really an option right now.

---

<div class="post-metadata">

**Author:** ![Jordan\_Feigenbaum](https://sea1.discourse-cdn.com/flex001/user_avatar/forum.barbellmedicine.com/jordan_feigenbaum/32/1315_2.png) [@Jordan\_Feigenbaum](https://forum.barbellmedicine.com/u/Jordan_Feigenbaum)\
**Post date:** [September 18, 2017, 6:45pm UTC](https://forum.barbellmedicine.com/t/rack-pull-height/161/2 "2017-09-18T18:45:00Z")

</div>

> [@Oarsman05](#):
>
> In the “Movement Explanation” section of The Bridge, it specifies that rack pulls should be done from mid-shin height or using elevated blocks. In my rack, the lowest I can set the pins puts the bar just barely below my knees. Is it better to lift from that height, or is there some other modification or alternative (RDL?) I should consider? Due to spacing issues the blocks aren’t really an option right now.

Figure out a way to use mats or blocks to space the bar about 2-3" higher than it is normally on the ground.
